BEC Audio dmc1 Instructions d'exploitation télécharger pdf (Page 5)

dmc1

2861 Congressman Lane | Dallas, Texas 75220 | 800.877.6631 | www.mssystems.com

Page

• Do not over-tighten the screws for the remote stations or the

master as the plastic face panels may crack or strip out.

• Use only M&S Systems certified replacement parts and have them

installed by an M&S Systems dealer or installer. Unauthorized

substitutions can result in fire, electric shock, or other hazards.

• Upon completion of any service or product repair, have the M&S

Systems dealer or installer conduct a safety check to ensure the

system is in proper operating condition.

• Use only a damp cloth to clean the dmc1 master and room stations.

Do not use liquid cleaners or aerosol cleaners.

Finish-Out Instructions

The finish-out installation should be made after the application of wall

covering material.

Tools required:

• #2 Phillips screwdriver

• Standard flat head screwdriver

• Wire stripper/cutter

• Level

Installing the Room Station

Collect all the connectors included in the room

station packages and place them in the wall

housing for use later. At each room station

location, strip approximately 4 inches of jacket

from the CAT5 wire and separate the colored

conductors from one another. Strip ½ inch of

insulation from each conductor as shown in figure 1.

Connect each colored conductor to its respective screw terminal. The

screw terminals are marked with the appropriate wire colors. Note:

Some screw terminals have more than one wire connected to them.

Figure 1 - CAT5 wire

1 2 3 4 5 6 7 8 9 10 ... 15 16

Pas de commentaire

BEC Audio dmc1 Instructions d'exploitation Page 5